#1
|
|||
|
I was playing a few hours ago, then this happened
I'm not sure if changing from windowed mode to full screen mode caused this, but I can no longer launch the game and get this error every time.
Screenshot file attached. EverQuest Windows - Application Error The instruction at 0x0000000001000F0CE referenced memory at 0x000000000FFFFFFFC. The memory could not be read. Click on OK to terminate the program | ||
#2
|
|||
|
I'm getting this same error message. Fresh install and the 50h files. Not sure if it's the screen resolution or what? Just Checked. I think it may have been that I was in full screen mode and switched back to windowed. I was able to log into green. I'd still like to change my resolution or go full screen though
| ||
Last edited by Calyps0; 10-25-2019 at 01:25 AM..
|
#3
|
|||
|
I am getting a similar error
| ||
#4
|
|||
|
Well, I found what I thought would be a fix for this problem in this thread here but the solution required a clean install into a folder not located in Program Files (x86). Anyhow, after doing all that, I was trying to figure out what the heck this "eqgame.exe patchme" was because there is no such file, only eqgame.exe
| ||
#5
|
|||
|
So not sure what happened, but doing a clean install of this game does not fix this issue.
| ||
#6
|
|||
|
"eqgame.exe patchme"
That's passing the parameter [patchme] to the eqgame.exe executable. Put a simpler way it tells the Everquest executable to NOT contact the patch servers. The recommended/simple way of launching P99's Everquest is via the [Launch Titanium.bat] batch file. | ||
|
|